Edge Lash Control Kit

Start with clean, dry lashes.

• Apply the WHISPER LIGHT FLEXIBLE BOND at the base of your natural lashes, focusing on the roots.
• Avoid the tips to prevent clumping, then wait for 30-60 seconds until the glue is tacky.

TIP: If your lashes look too wet, use your fingertip or a clean spoolie to remove any excess.

• Gently remove your chosen lash cluster from the cartridge with your fingers, to prevent breakage.
• Using the wand, gently place the EDGE or EDGE X Gossamers under your natural lashes, as close to the lash line as possible.
• Following the lash map, start with the largest cluster you wish to wear, applying it to the outer corner of your eye.
• Select the next size, and apply it with a slight overlap - continue this process until you place the final lash cluster near the inner corner.

• Ensure the Gossamers are 1-2mm above the waterline, with the roots of your natural lashes still visible.
• Fuse, or clamp, your top lashes using the wand to ensure that your natural lashes and the Gossamers are pressed tightly together.
• Finally, lock your look in place with the WATERPROOF SEALER to ensure all-day wear by applying a thin coat on the underside of your new eyelashes.

Remove with an oil-based eyelash cleanser, as per the product instructions.